Signal SS650 Instruction Manual

PLITSTR247 REV. F 12/9/13 INSTALLATION AND INSTRUCTION MANUAL SIRENSIRENSIRENSIREN SS650SS650SS650SS650----013013013013 SIREN and Light Cont

-8- Light Control Switches (LCS652 only) The LCS652 also has two additional switches located in the center of the face (SW1 and SW2). These two swit

-9- Troubleshooting Symptom Possible Cause Check No power Check power Wires Fuse or circuit breaker blown When activated, power to both Term

-10- ONE YEAR LIMITED WARRANTY The manufacturer warrants each new product against factory defects in material and workmanship for one year

-i- NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and information, contained in this manual a

-1- Specifications Input Voltage 10 - 16 VDC (negative ground) Audio Input Current 8 Amps @ 13.6 VDC (100W speaker) Standby Current Enable wire off 0m

-2- Proper installation of the unit is essential for years of safe, reliable operation. Please read all instructions before installing the unit. Fai

-3- Electrical Connections Wire Size and Termination Electrical connections to this unit are made through the green 10-terminal connector located in

-4- (Electrical Connections CONT’D) MANDATORY ELECTRICAL CONNECTIONS Ground - Connect terminal 5 to the negative terminal of the battery. (You MU

-5- DIP Switch Settings DIP SWITCH FUNCTION UP (Off) (default) DOWN (On) 1 AUX Wire Polarity Positive switching Negative switching 2 Hands Free Cycl

-6- Optional Tone Programming The SS650 and LCS652 can be programmed to produce 6 different tones/sounds by activating its various functions: Funct

-7- Operation Wail/Off/Yelp Switch This is the 3-position button used for basic operation of the siren. While in the Wail or Yelp positions the sire